To connect to a Call Pilot:
1. Connect laptop or PC via the crossover cable and then change the IP address of your Laptop/PC to
192.168.110.11 .
To change IP of laptop/PC go to network adaptor (via control panel,netowrk settings) and click properties then change IP and reboot.
2. Open Internet browser and type
192.168.110.10
Once you get to the login page via your browser it will ask for a password....the password is the same digits you enter from a set once you Press F983 and Log: 102
XXXX or 1002
XXXX (102 or 1002 is the System manager mailbox and
XXXX is the password)so enter
XXXX only, then you will have access to the Call Pilot admin functions via web browser.
To install Call Pilot to a network/Lan:
1. Ask I.T./Network administrator for an IP address.
2. While logged in the Call Pilot via method above click the configuration tab near the bottom and change the IP of the Call Pilot to the same as the IP given to you by the Network Admin.
3. Logout and unplug your crossover cable from Call Pilot.
3. Connect a regular patch cord from the Call pilot to the network hub/switch.
4. Reboot Call Pilot
5. Now when accessing Call Pilot from and PC on the network enter the
NEW IP of Call Pilot.
Authorized Nortel Dealer
Private email: sbwdaddy@yahoo.ca