CDMA Ethernet router CDMA Ethernet router mfbrown (IS/IT--Management) (OP) 25 Jun 03 10:29 Is there such a device that would/could be able to be used as a 3G/CDMA to Ethernet router? RE: CDMA Ethernet router JezW (IS/IT--Management) 4 Jul 03 05:02 What are you tring to do ??Jezw RE: CDMA Ethernet router mfbrown (IS/IT--Management) (OP) 7 Jul 03 09:27 Everyone is hooked on using the 3G network as a mobile solution. I want to eliminate cabling, DSL, and installation costs by implementing a 3G wireless solution for a company that has hundreds of 2-3 user offices. All the locations are along main highways that are in the 3G network. They require low bandwidth. I want to take the 3G/CDMA and through a low-cost device, switch it over to ethernet to use on the 2-3 user LAN. RE: CDMA Ethernet router carl0527 (TechnicalUser) 6 Aug 03 13:29 Have you had any luck with your search? I too and looking to take cdma data route it to a small ethernet(wireless and wired). RE: CDMA Ethernet router mfbrown (IS/IT--Management) (OP) 6 Aug 03 15:50 I have found something. It has a CDMA input and a serial or USB output. But no ethernet. RE: CDMA Ethernet router SysCoDeveloper (IS/IT--Management) 8 Oct 03 06:33 Hello,Try these following links for router over GPRS:http://www.comtech.uk.com/Products/gprs/gprsrouter.htmhttp://www.idtuk.com/downloads/IDT_GPRS_Router.pdfhttp://www.sarian.co.uk/products/gprs/welcome.htmhttp://www.sgs-system.cz/data/sgs-router-gprs-e.pdfhttp://www.ipmotion.com/23443/index.htmlHope it helps, feedback welcome ;-)Best regards,André Liechti RE: CDMA Ethernet router mfbrown (IS/IT--Management) (OP) 8 Oct 03 12:06 This is excellent information. Thank you very much. RE: CDMA Ethernet router nneil (TechnicalUser) 18 Oct 03 20:19 Try these guys for their 1X Mobile Gateway ethernet switch/router/CDMA-1xRTT modem device.http://www.proxicast.com/http://www.proxicast.com/Press/PRX-PR-YP1a.pdf RE: CDMA Ethernet router mikethebike2032 (Vendor) 10 Dec 03 16:28 Take a look at http://www.ctekproducts.com/Product_Area/S4100%20Prod.h... RE: CDMA Ethernet router jst169 (IS/IT--Management) 14 Jun 04 19:16 I recently had a chance to use the Proxicast LAN-Cell 1x mobile gateway - you can see it at http://www.proxicast.com/1XMG/index.htm. It is very slick and works well as advertised, but it is enclosed in a very rugged steel box that you could drive a truck over which might be overkill. The people at Proxicast were very helpful and did all the CDMA configuration before it was shipped to me, so it worked flawlessly out of the box. To test the unit we put it in my car and me, a notebook computer and one of my coworkers drove all over Chicago surfing the web via the Verizon Wireless 1x network. It worked perfectly. The little antenna has magnet mount that we stuck out the window and on the roof of the car. It uses 12 volts so we were able to power it with cigarette lighter and 2mm adapter. I have only have worked with one of units so far, but I would recommend the LAN-Cell to anyone looking for a CDMA ethernet router. RE: CDMA Ethernet router Z3GALAN (TechnicalUser) 20 Jul 04 12:35 Here is a flexible product can support both WLAN and LAN over CDMA 1x/GPRS/EV-DO/UMTS. http://www.chinatopglobal.com/products_6_1.htmSpecsheet identifys five interfaces: WWAN (CDMA1x/GPRS/3G), WAN, WLAN (802.11a/b/g), LAN, and RS-232. Joint PR with Lucent in 2003 said the product works with Lucent's 3G infrastructures (both CDMA2000/EV-DO and WCDMA/UMTS). RE: CDMA Ethernet router NetworkHiker (Programmer) 28 Mar 05 19:27 These are great links. Is there a straight ethernet interface with Cell on the other end without all the routing features that would take data off a wire and transmit?