×
INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Contact US

Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

DS1 (T-1) Clocking?

DS1 (T-1) Clocking?

DS1 (T-1) Clocking?

(OP)
How do I check/change where a T-1 is clocking from?  I am experiencing some miss-directed DID numbers on a incoming T-1 circuit, as well as, "sync" errors (error type 1793, 1, 513) when a run a "display errors" report.

My provider is telling me that I need to be clocking off of them and I am not sure how to check that setting.

I have done a "cha synchronization" to see if I can change the sync to loop or slave, but that doesn't seem to be the right place for that command.

Any suggestions...

RE: DS1 (T-1) Clocking?

You would need to go to "change Synchronization" this page will let you pick the t-1 you get your time from and a back up just in case.

So many buttons So little time
Thanks All
Phoneman2

RE: DS1 (T-1) Clocking?

I'm not sure what loop or slave is, I didn't see that as an option on my G3-R8. I have PRIs. As far as you DIDs go you don't have any conversion going on do you, is it happening to the same DIDs or to all of them?

So many buttons So little time
Thanks All
Phoneman2

RE: DS1 (T-1) Clocking?

There is no loop or slave.
note the board no. of the T1 in the switch.
do a change sync.
overwrite or add to primary that ds1 pack no.
save it, takes a few minutes for the sync to kick in.
keep doing a status sync until it shows up.

if it dosen't then you will have to disable sync.
set sync to the T! board.


hope this helps....

RE: DS1 (T-1) Clocking?

Hi,
You can set the synchro on ch synch.
But if you wont to change the signaling mode than you shoud go to ch ds1 xxxx.

MKD

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members! Already a Member? Login


Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close