External Paging on Norstar MICS 12 32
External Paging on Norstar MICS 12 32
(OP)
We have a client and all the speakers in shop are dead-the horns are all good but the page port off the MICS has no audio coming out on it. We are on Black Slate. We rebooted system still the same no audio.
Can we set up paging on a line port ??? Do we need some external device ??
Can we set up paging on a line port ??? Do we need some external device ??
RE: External Paging on Norstar MICS 12 32
Then the page port is blown.
To be sure, did you connect a working butt set to the page port and have somebody page through it or enter digits to get the tones?
Is the Amp cable 100% snug in?
Did you try another 25pr Amp cable?
"Do we need some external device ??"
Depends...
A small site you could loop a couple of self amplified horns.
Any bigger you use an amplifier with amplified horns and speakers.
"Can we set up paging on a line port ???"
Yes you can use a trunk port if you have a spare.
It is limited because you cannot page through phones at the same time or use different zones.
You can however add ceiling speakers in the hallways etc and/or add a zone controller module.
Check to see what type of horn, ie 70 volts and 1 pair or 2 required.
I prefer Bogen myself, one pair for power and audio, no need for a bloody shelf for the amp.
=----(((((((((()----=
www.curlycord.com
Toronto, Canada
Add me to LinkedIN
RE: External Paging on Norstar MICS 12 32
RE: External Paging on Norstar MICS 12 32
WMT1A will most likely not work but you can try to take a 24V DC power supply and loop that into series with the speakers and that should work.
Joe
FHandw, ACSS, ACIS
https://www.millsidetc.com/
RE: External Paging on Norstar MICS 12 32
=----(((((((((()----=
www.curlycord.com
Toronto, Canada
Add me to LinkedIN
RE: External Paging on Norstar MICS 12 32