ANI Delivery to Definity PBX?
ANI Delivery to Definity PBX?
(OP)
TWO PART QUESTION:
1. Are there certain programming steps that need to be taken on the Definity (G3si V8.1.xx) to allow ANI (Caller-ID) to be displayed on 6400 & 8400 display sets? We currently have a ISDN-PRI for local calls and flexpath for LD. We are having our local CO turn the Caller-ID feature up on the ISDN right now until we reprovision our LD trunk to ISDN-PRI. Does anything in the PBX need to be done to make this work? ie: "cha trunk grou X", "sys para multi-freq", etc..?
2. Can the PBX send that information (caller-id) to a CDR device in order to track "ALL" inbound calls. I know that that would be a great deal of data, but this is strongly suggested via the Government unfortunately...
Thanks for any and all input...
1. Are there certain programming steps that need to be taken on the Definity (G3si V8.1.xx) to allow ANI (Caller-ID) to be displayed on 6400 & 8400 display sets? We currently have a ISDN-PRI for local calls and flexpath for LD. We are having our local CO turn the Caller-ID feature up on the ISDN right now until we reprovision our LD trunk to ISDN-PRI. Does anything in the PBX need to be done to make this work? ie: "cha trunk grou X", "sys para multi-freq", etc..?
2. Can the PBX send that information (caller-id) to a CDR device in order to track "ALL" inbound calls. I know that that would be a great deal of data, but this is strongly suggested via the Government unfortunately...
Thanks for any and all input...
RE: ANI Delivery to Definity PBX?
Robert Harris
Communications Advantage
www.communicationsadvantage.com
RE: ANI Delivery to Definity PBX?
RE: ANI Delivery to Definity PBX?
To shutdown/restart the CMS server, enter the following command at the # prompt.:
# /usr/sbin/shutdown -y -g0 -i6
Note: -y is the yes or no verification;-g0 is grace period, Zero seconds ;-i6 option shuts down and restarts the operating system. If you only want to shut down (not reboot) change the -i6 to -i0. Hope this helps.
RE: ANI Delivery to Definity PBX?
Hope this helps,
Chris
RE: ANI Delivery to Definity PBX?
If you do a ch trunk xx look for the settings "Send Name" "Send Connected Number" "Send calling Number"
Also look at the page "ch isdn pub" this is were you would define your outgoing numbers. IF your DID number range is 513-123-4500/4599 you would put 4 as the len 45 as the ext. and 513123 as the prefix, total cpn len is 10. Hope this helps
RE: ANI Delivery to Definity PBX?
José
Please let me know if this was helpful