I just recently installed a carriage belt on my printer cause it was broken. After I installed the new belt the cartridge carriage would no longer work properly. When the power gets turned on the carriage will move over to the right and bumps there 2-3 times which is ok, then it returns to the saddle and it just rattles there 4-5 times acting like if it not seating properly...soon after that all 3 orange lights comes on not blinking under the Cancel button...Anyone knows how to fix this problem?
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.