Wrong time is displayed on 6408D+ phones

[smetse]

Wrong time is displayed on 6408D+ phones on G3si V8.2

1. System Updates Time On Station Displays? Y
2. Busy/Release the station doesn’t help.
3. Unplug/Replug phone in jack doesn’t help.
4. Using a RJ-45 cord instead of an RJ-11 doesn’t help.

Can anybody tell me what else I should try?

 

[rgtrgt]

is the PBX time correct? set time

 

[smetse]

Yes, the system time is correct.
Phone displays show correct date, but time is 8 hours ahead.
We just started using 6408D+ phones. There were no phones with displays before on this system.

 

[phoneguy55]

did you try adding a time/date button and pressing it?

Also under 'cha sys feat' system updates time on station displays = Y.

 

[smetse]

“did you try adding a time/date button and pressing it?”

Yes.

“Also under 'cha sys feat' system updates time on station displays = Y.”

Please see my original post. It is set to Y.

 

[Zen216]

check dst rules make note of which rule is defined,, (most likely rule 1)
Then on set time, make sure rule # is same as the one defined in daylight savings.. (it is probably 0) and on change locations make sure rule is also same


display daylight-savings-rules Page 1 of 2
DAYLIGHT SAVINGS RULES

Rule Change Day Month Date Time Increment

0: No Daylight Savings

1: Start: first Sunday on or after March 8 at 02:00 01:00
Stop: first Sunday on or after November 1 at 02:00


set time Page 1 of 1
DATE AND TIME

DATE

Day of the Week: Thursday Month: May
Day of the Month: 17 Year: 2007

TIME

Hour: 9 Minute: 28 Second: 18 Type: Daylight Savings

Daylight Savings Rule: 1


display locations Page 1 of 16
LOCATIONS

ARS Prefix 1 Required For 10-Digit NANP Calls? n

Loc. Name Timezone Rule NPA ARS Attd Pre- Proxy Sel.
No. Offset FAC FAC fix Rte. Pat.
1: Main + 00:00 1 413

 

[smetse]

Zen216,

I actually checked all this stuff before and did not find anything wrong, BUT just did it again and found that in “locations” the “Timezone Offset” was set to +08:00. That exactly what was wrong – time was 8 hours ahead on phone displays.
After correcting this field everything is OK now.

Thank you very much Zen216!
The problem is solved.

 

[Zen216]

glad I could help