adkmom
Technical User
- Nov 13, 2002
- 71
Hi all,
Running a dual-boot of 98SE & W2K. For some strange reason, my Win98 started coming up in safe mode-looking form. The screen doesn't say "safe mode" in the corners though- weird. You cannot change the display via properties. It's 640 x 480, 256 colors. The prop. shows my GF3 Ti200 card as the adapter. The monitor driver is also installed. There are no exclamation points in device manager- I even expanded all the headings to show everything. Restart or shutdown doesn't change it. I ran scandisk & did a defrag just to try all I could- same thing. I even went into W2K via "F8" & tried the "restart normally" from the menu I knew was available there- no go. My W2K install runs & looks fine.
Can anyone advise?
Mom
Celeron 1.3Ghz, 512 SDRAM, Win98/W2K dual, 100GB HD, GF3 Ti200, Hitachi/Plextor opticals, onboard Yamaha audio.
Running a dual-boot of 98SE & W2K. For some strange reason, my Win98 started coming up in safe mode-looking form. The screen doesn't say "safe mode" in the corners though- weird. You cannot change the display via properties. It's 640 x 480, 256 colors. The prop. shows my GF3 Ti200 card as the adapter. The monitor driver is also installed. There are no exclamation points in device manager- I even expanded all the headings to show everything. Restart or shutdown doesn't change it. I ran scandisk & did a defrag just to try all I could- same thing. I even went into W2K via "F8" & tried the "restart normally" from the menu I knew was available there- no go. My W2K install runs & looks fine.
Can anyone advise?
Mom
Celeron 1.3Ghz, 512 SDRAM, Win98/W2K dual, 100GB HD, GF3 Ti200, Hitachi/Plextor opticals, onboard Yamaha audio.