Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
win 200 and RAID 100 on KT7A
- Thread starter yacq
- Start date
When installing win2k it ask in the first screen to press F6 when using a third party scsi or raid driver. this might be the problem. That your driver is not correctly installed.
It is easier to give a good solution if you can tell what the blue screen says.
Arjan Meskers
Junior Software Developper
The Netherlands
It is easier to give a good solution if you can tell what the blue screen says.
Arjan Meskers
Junior Software Developper
The Netherlands
I had the same problem on the KT7A. Drivers were on a floppy disk but still wouldn't load. Just connect your drive to the IDE port first, do the install, then install the Highpoint driver in W2K. Shut down, move the cable over to the RAID connectors and reboot. Configure the drive you will boot from by pressing <CTRL-H> during boot. Load W2K, if no problems, shut it down, reboot and create your RAID.
Worked for me, hope this helps.
Worked for me, hope this helps.
- Status
Similar threads
- Locked
- Question
