Wierd PRI/Target line issue 2

[Norstarguy]

Hello guys-

I've got a system I'm trying to program remotely that I'm having an issue with and can't seem to figure out.

I've done numerous PRI installs without a hitch, but haven't seen this problem before. Got the target lines built, got outbound working fine with the routing, etc- however the calls aren't being routed properly across the target lines...in fact, they won't ever ring on the targets. Only rolls in to the prime set on the PRI Trunks, ie x6800 in this case.

I have verified from the provider end that they are sending me 4 digits (as is programmed in the MICS), so that isn't the issue, had their NOC on the phone verifying that they can see the 4 digits going out to my MICS on test calls...but I've been beating my head against a wall on this for the last two days.

Any ideas? I'm really of the opinion that it's something screwy on the circuit itself, but trying to tell VZ that has its own "complications" LOL.

TIA-

NG

 

[jerryreeve]

On my similar problem I have 6.1 MR and a NAM 4.1.05 SW.
I scrubbed and re-built the 6.1 from default: the problem went away for about a week. then came back.
I found out that I had NAM 4.1.05.G software and upgraded this to 4.1.05H software on the NAM and it has been just a week so I am still holding my breath on this (Face is dark purple right now) for about another week before I will consider this closed. I had ITAS second level on this but they couldn't figure it out at this point. I am hoping that the "H" software will take care of it.

I will let you know in about a week

----------------------------
JerryReeve
Communications Systems Int'l
com-sys.com

 

[Norstarguy]

I've got a new 4.1 cartridge coming in today, once that's installed on the customer's switch I'll rebuild the PRI and see what happens then.

I'll post an update as soon as I see what happens.

NG