Why display following error when I installed the image of cat5000-sup.

[victorjob]

Why display following error when I installed the image of cat5000-sup.4-5-13a.bin on cat2926T ??

Help me!

Thanks

Sry r gi.



ATE0
ATS0=1



ROM Power Up Diagnostics of Aug 19 1997

Init NVRAM Log
LED Test ................... done
ROM Checksum ............... passed
Dual Port RAM r/w Test ..... passed
ID PROM .................... passed
System DRAM Size(mb) ....... 16
DRAM Data Bus Test ......... passed
DRAM Address Test .......... passed
DRAM Byte/Word Access Test .. passed
EARL Test .................. passed


BOOTROM Version 2.4(1), Dated Aug 19 1997 11:00:58
BOOT date: 05/05/03 BOOT time: 08:33:13
Uncompressing NMP image. This will take a minute...
CsoSsesCnoe

20 a 50:35 SS5MDOue1i nie
20 a 50:41 SS5MDOue2i nie
20 a 50:41 PG--OTOTt11ji
Atmtclgu..
Etrpswr:.trpswr:Etrpswr:Etrpswr:Etrpswr:Etrpswr:

 

[fmonteiro]

I would like you to make sure you are using the correct image. Image to be used in the 2926 is the same one used by supervisor I or II. The problem is that the image for supervisor III has the same name. If you have access to CCO try the Catalyst 5000 Flash.

By the way, do you have any other 2926 up and running? Could you upload the IOS to a TFTP server? If you could do that we are saved. If you have a 2926 but can not upload, just post a sh version (or equivalent) and sh flash commands.

If anybody else has a 2926 up and running would you, please, post a sh version (or equivalent) and sh flash commands. I would like to check the file size with CCO.