Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
What is a Trap Capture?
- Thread starter ciscomeo
- Start date
Hi,
trapcapture is a small util that comes with the DSS console/ sniffview. It is used the capture alarms send by the DSS sniffer boxes. On a DSS you can give the IP of the console/sniffview, and there the alarms are sent to.
Yuo can find more info in the DSS manual.
regards,
Robert
Robert A.H. Wullems
Sniffer University Instructor
SCM/CNX/MSCA
trapcapture is a small util that comes with the DSS console/ sniffview. It is used the capture alarms send by the DSS sniffer boxes. On a DSS you can give the IP of the console/sniffview, and there the alarms are sent to.
Yuo can find more info in the DSS manual.
regards,
Robert
Robert A.H. Wullems
Sniffer University Instructor
SCM/CNX/MSCA
AlfSutherland
Technical User
Hi,
Further to Robert's post.
"TrapCapture" is a SNMP Trap management utility, that is install as part of the Sniffer Distributed client-side application. It allows you to view and priorities traps (alarms) based on alarms that have been breached in the Sniffer GUI on your Sniffer Distributed Appliance(s).
To take advantage of this feature, you need to enable SNMP and add your IP address of you pc, within the "SNMP" tab, within either "probeviewer" or the "SnifView", agent's "config" option.
If you are not using this application, it can be removed by deleting it from "Start Up" menu in "start", "programs".
Alf
Further to Robert's post.
"TrapCapture" is a SNMP Trap management utility, that is install as part of the Sniffer Distributed client-side application. It allows you to view and priorities traps (alarms) based on alarms that have been breached in the Sniffer GUI on your Sniffer Distributed Appliance(s).
To take advantage of this feature, you need to enable SNMP and add your IP address of you pc, within the "SNMP" tab, within either "probeviewer" or the "SnifView", agent's "config" option.
If you are not using this application, it can be removed by deleting it from "Start Up" menu in "start", "programs".
Alf
- Status
Similar threads
- Locked
- Question