Web Interface for firewall is gone

[fixafone123]

I recently took over the network here and we have a Cisco 6513 witht the firewall module. I used to be able to log into the web interface to setup the firewall but cannot log into it or ping it anymore. Any way to restart it? I dont know much about Cisco other than the basics (turning ports on/off, saving configs, etc).


Thanks,
Kyle K

 

[intelwizrd]

use a console cable to connect to it and see if it has been turned off. post a sanitized config and someone can help you with the commands to get it back on.

----------------------------
Josh
CCNA, MCSE 2003(in progress)

 

[fixafone123]

I can log into it via SSH, do I still have to connect a console cable?

 

[intelwizrd]

no, "show run" and then copy the running config and post it. clean it up (mask the first octets of ips and remove passwords) first though

----------------------------
Josh
CCNA, MCSE 2003(in progress)

 

[fixafone123]

version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname ******.***.***
!
boot system flash sup-bootflash:s72033-pk9s-mz.122-17a.SX1.bin
aaa new-model
enable secret 5 *****************************
!
username ***** password 0 ********
clock timezone CST -6
clock summer-time EST recurring
firewall module 4 vlan-group 10
firewall vlan-group 10 300,400
no ip subnet-zero
!
!
ip domain-name ****.edu
ip name-server ***.***.120.1
ip name-server ***.***.135.4
!
ip dhcp pool *****
network 192.168.200.0 255.255.255.0
default-router 192.168.200.254
dns-server ***.***.120.1 ***.***.135.4
lease 0 8
!
no ip igmp snooping
no mpls ldp logging neighbor-changes
no mls flow ip
no mls flow ipv6
!
no spanning-tree optimize bpdu transmission
spanning-tree extend system-id
diagnostic cns publish cisco.cns.device.diag_results
diagnostic cns subscribe cisco.cns.device.diag_commands
!
redundancy
mode rpr-plus
main-cpu
auto-sync running-config
auto-sync standard
!
vlan internal allocation policy ascending
!
!



Hope this helps, there was more to it, all of the ports but I ommitted those entries. Let me know if you need more info.

Thanks

 

[fixafone123]

The web interface is set up already it just appears to have stopped working I just need to figure out how to restart it.

 

[fixafone123]

I AM AN IDIOT!

apparently you have to connect to it via secure http (

https://).

I wasnt, thanks for your help though.

 

[intelwizrd]

i actully thought about saying that, but then i figured you already tried that.

no big deal, i have done the same thing twice so far this month and it isn't even halfway over yet.

----------------------------
Josh
CCNA, MCSE 2003(in progress)