VPN to Corporate SUBNETS Problems

[explosivo]

I created a Route-Based VPN from a Remote site to access Corporate Network.
Netscreen Solution nskb4294

Remote Site: 192.168.1.X
Corporate Net: 10.178.1.X

I can't ping, trace-route or VNC to ANY HOSTS in other subnets in the Corporate Netowrk from Remote Site
Local Network: 10.178.1.X
Other Subnets: 10.178.2.X, 10.178.3.X 10.178.4.X etc....

I have added some trust-vr routes on the the "Remote Netscreen" to access the other subnets within the corporate network, but I couldn't get anywhere. I even added a route that was 10.178.0.0 / 16 and failure.
What INTERFACE / GATEWAY IP ADDRESS Should I be using??

There are also policies on both Netscreens
Corporate Netscreen
Source: 10.178.0.0/16 Destination: 192.168.1.0

Remote Netscreen
Source: 192.168.1.0/24 Destination: 10.178.0.0/16

Any help would be greatly appreciated!!

 

[MaxPipeline]

Run debug flow basic from CLI on both Netscreens. Paste output of traffic to and from your host PC. This should show you what is happening to your traffic.