Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

VPN failover

Status
Not open for further replies.
woongko

woongko

IS-IT--Management
Apr 8, 2005
11
US
Is there a way to configure VPN failover with two interfaces(Serial, FastEthernet) on a single CISCO router?
This is a scenario. Site A and site B are connected through IPSec VPN with a tunnel on each interface. If Serial VPN goes down, Ethernet VPN takes over the VPN. Any lead on IOS configuration will be appreciated. Thanks.
 
Sort by date Sort by votes
Just keep both tunnels up and use a routing protocol such as OSPF or EIGRP, when the first path goes down the protocol will recalculate and decide the new route.

MCP,CCA,CCNA, Net+, Half CCNP...
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

quazimotto
  • Locked
  • Question
Cisco ASA_5505 VPN to Juniper_SRX210 VPN IS UP_ No Traffic!!!!!!
Replies
0
Views
263
quazimotto
quazimotto
tviman
  • Locked
  • Question
Same subnet on each side of a VPN 1
Replies
2
Views
268
tviman
tviman
DigitalG
  • Locked
  • Question
cisco rv180 vpn tunnel between a rv130
Replies
0
Views
214
DigitalG
DigitalG
LORDxGOLD
  • Locked
  • Question
WAN port failover - Cisco ASA 5512x
Replies
1
Views
220
iggsterman
iggsterman
stayconnected
  • Locked
  • Question
How to reliably configure a secondary failover route for Layer 3 Cisco Switch?
Replies
11
Views
588
iggsterman
iggsterman

Part and Inventory Search

Sponsor

Back
Top