VPN Client 4.6

[colinT23]

Hi,

I am trying to improve on the speed of my current VPN to my PIX 501. I am trying to allow one of my clients to VPN into my SOHO network using Cisco VPN Client 4.6. Using 3DES, MD5 and DH group2 works fine. If I try using AES 128 with SHA and DH group 5 the VPN client cannot connect, giving me a 412-remote peer not responding error. I'm sure the Cisco VPN Client software can handle AES. Incidentally, I use the PDM to create the tunnel. I know not many people here like this tool but it works fine when using DES/3DES etc! Any ideas ?

Regards Colin.

 

[dopehead]

what does "debug cry isakmp" on your pix give you of output ?


Network Systems Engineer
CCNA/CQS/CCSP/Infosec

 

[colinT23]

Hi,

Thanks for the reply. Sorry it took so long to get back to you. Entering that command gives me no output at all! Is this because I am using PDM to configure the PIX ?

Regards Colin.

 

[LloydSev]

You should enter "debug cry isakmp" as dopehead suggested, but enter it at the console in privelaged mode, or even by telnet if you have that option enabled.

Computer/Network Technician
CCNA

 

[colinT23]

Hi,

I entered the command using the CLI via the console (not PDM) whist in Config mode. Still get nothing. Any ideas ?

Regards Colin.

 

[dopehead]

Try :
"logging console debug"
"logging on"

to disable, "no logging on"



Network Systems Engineer
CCNA/CQS/CCSP/Infosec