I just noticed. I have an S8300 setup with digital, analog and ip hardphones administered to it. All phones except the ip phones (4612) saved their volume setting after I changed and hung up. Why can't the ip phones remember the volume settings? Are there any way (adjustments in definity/ASA) around it?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Volume settings on phones 3
- Thread starter no25
- Start date
-
1
- #2
This can be fixed with the "change terminal-parameters" command, but only by Avaya has access to the screen. You may be able to call and ask them to change the Terminal Parameters for 4600 series phones so that they retain the settings between calls.
IPSI
IPSI
- Thread starter
- #3
- Thread starter
- #4
dmoore7648
IS-IT--Management
No, the setting is on the switch side.
- Thread starter
- #6
Will it cost you? Well, Someone at Avaya will have to press a key on thier keyboard to help you and the whole process will take at least one whole minute minute, so Avaya will obviously have to charge you about$125.
I don't actually know if there will be a charge, there should not be since this does not require a change to the license file, and it not something that a customer can do on their own, but who knows! If you have a good relationsip with any of your local service techs, you might get them to do it for you.
IPSI
I don't actually know if there will be a charge, there should not be since this does not require a change to the license file, and it not something that a customer can do on their own, but who knows! If you have a good relationsip with any of your local service techs, you might get them to do it for you.
IPSI
dmoore7648
IS-IT--Management
There was no charge when I called in to have this fixed.
- Thread starter
- #9
-
1
- #10
A modem should have been installed with your S8300 in one of the USB ports.
Logins of 'craft' or higher can do it. I'm not sure if the biz partner 'dadmin' login has the permission, but I would think so.
And by the way, it is as simple as IPSI said. 'Cha terminal-p 6400', set 'Custom' to 'y', then change the 'IP Phone' entry to the same as the '6400' entry, 'retain.....', and as always...'sa t'.
Logins of 'craft' or higher can do it. I'm not sure if the biz partner 'dadmin' login has the permission, but I would think so.
And by the way, it is as simple as IPSI said. 'Cha terminal-p 6400', set 'Custom' to 'y', then change the 'IP Phone' entry to the same as the '6400' entry, 'retain.....', and as always...'sa t'.
- Thread starter
- #11
- Thread starter
- #12
-
1
- #13
- Status
Similar threads
- Locked
- Question
- Locked
- Question