Has any one installed a VCM card in an IPO to communicate with a S8700? I have installed the card already, but nothing in the manager comes up to try and configure this device. I have searched the web and getting nothing there either. Any help on this would be greatly appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Voice Compression Module for IPO
- Thread starter Hitman11
- Start date
The good news... There is no configuration for the VCM card.
Bad news... you need to build an IP trunk, and it needs to be built on the IP Office side and the S8700 side, so I hope you have enough right to use and licesning on the s8700. Basicly, the IP Office has an IP address, and so does the CLAN and MedPro. I'm not that familiar with the S8700, but on the IP Office side, you add an IP trunk, set it's gateway to the s8700 IP, and match your H.323 mode to (probably) QSIG. There is a doc out there from Avaya on connecting to an S8500 (I think it's 8500). Respond back if you need help with specific details.
Bad news... you need to build an IP trunk, and it needs to be built on the IP Office side and the S8700 side, so I hope you have enough right to use and licesning on the s8700. Basicly, the IP Office has an IP address, and so does the CLAN and MedPro. I'm not that familiar with the S8700, but on the IP Office side, you add an IP trunk, set it's gateway to the s8700 IP, and match your H.323 mode to (probably) QSIG. There is a doc out there from Avaya on connecting to an S8500 (I think it's 8500). Respond back if you need help with specific details.
- Thread starter
- #4
GDVillarreal
IS-IT--Management
In Manager, in the Line configuration, click New, and configure the VoIP parameters, as IPOdan explains, read the PDFs on the Doc CD.
- Status
