I have a site here on a LAN with a CCM cluster. It is a campus environment therefore I have 4 different buildings on the campus with the primary building housing the CCM cluster, unity, voice gateways etc... I need to route 911 from the other buildings on the campus but still have it signal from which building it's coming from (not just the primary building).
In other words all the buildings tie to the HQ building via the LAN, but when you dial 911, the call routes out of the HQ routers (Voice gateways). Is there any tips or tricks to configure it so that each building that dials 911 shows the address of the building to telco and not the HQ address/destination.
BLDG1-------------------HQ----------------------BLDG2
BLDG3-------------------HQ--------------------- BLDG4
BLDG5-------------------HQ
Thanks,
-Andrae
In other words all the buildings tie to the HQ building via the LAN, but when you dial 911, the call routes out of the HQ routers (Voice gateways). Is there any tips or tricks to configure it so that each building that dials 911 shows the address of the building to telco and not the HQ address/destination.
BLDG1-------------------HQ----------------------BLDG2
BLDG3-------------------HQ--------------------- BLDG4
BLDG5-------------------HQ
Thanks,
-Andrae