Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Voalte integration ?

Status
Not open for further replies.

NewNic

IS-IT--Management
Joined
Nov 14, 2003
Messages
525
Location
US
Does anyone have any experience integrating a voalte (wireless pbx) into CM / SMGR
The integration iv been given says just make it a sip tie line with no specifics.

Looking for an integration guide and features that are lost.

Looked on Dev with no results
 
in the AVAYA create an IP-node name with the address of the Voalte.

Then build a signaling group:
change signaling-group 2 Page 1 of 2
SIGNALING GROUP

Group Number: 2 Group Type: sip
IMS Enabled? n Transport Method: tls
Q-SIP? n
IP Video? n Enforce SIPS URI for SRTP? y
Peer Detection Enabled? y Peer Server: Others



Near-end Node Name: procr Far-end Node Name: Voalte
Near-end Listen Port: 5061 Far-end Listen Port: 5061
Far-end Network Region:

Far-end Domain: voalte.mycompany.com
Bypass If IP Threshold Exceeded? n
Incoming Dialog Loopbacks: eliminate RFC 3389 Comfort Noise? n
DTMF over IP: rtp-payload Direct IP-IP Audio Connections? n
Session Establishment Timer(min): 120 IP Audio Hairpinning? n
Enable Layer 3 Test? n
Alternate Route Timer(sec): 6

Then build a trunk group:
change trunk-group 2 Page 1 of 21
TRUNK GROUP

Group Number: 2 Group Type: sip CDR Reports: y
Group Name: SIP COR: 1 TN: 1 TAC: *012
Direction: two-way Outgoing Display? n
Dial Access? n Night Service:
Queue Length: 0
Service Type: tie Auth Code? n
Member Assignment Method: auto
Signaling Group: 12
Number of Members: 24

You'll likely have to make some minor tweaks, but this is from a working SIP trunk in my system.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top