Vector Looping

[NewbieCarol]

Does anyone know how to perform the same set of vector steps only twice WITHOUT having to type in that set of commands twice? For example, I have a menu that our customers will access when they call in. I want to give them an opportunity to repeat the menu, but only one time and then disconnect. I don't want to type in the same set of instructions twice. When I do that I don't have enough empty vector lines to program the rest of the vector. I just thought if there was a way to set up a "command" counter.

Thanks

 

[041773]

Copy your vector and paste it on the message board, it can probably be simplified. You're using all 32 lines of programming ?

 

[sjforcum]

You could use a goto command at the end of vector 1 and have it unconditionally goto another vector...but there's an awful lot of bloat there. Why have it disconnect? 9 times out of 10 that customer will call right back, you'll lose out on any potential rounding savings, & you'll frustrate the customer.

There is no command to do what you describe that I know of other than re-typing the whole menu.