oneciscokid
Technical User
When you use the uptime or top command for example, you're given a load average. What exactly is a low, normal and high average? What should I be looking for exactly? I don't believe it's in percentage either.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
uptime/top - load average
- Thread starter oneciscokid
- Start date
- Status
This confuses a lot of people, and the answer isn't really ever clear.
My personal experience is that the load average needs to remain below 1.00 per CPU on the machine. I count that by physical sockets, and don't use the same ratio for DUO CPUs or dual core....
I'm sure some googling will reveal a more informed answer, but as a I say, I see things go poorly when load runs greater than 1.0 per CPU.
(i.e. 4 CPUs, load of 2.5, not too worried... probably stressing RAM or disk more than CPU).
Good luck.
D.E.R. Management - IT Project Management Consulting
My personal experience is that the load average needs to remain below 1.00 per CPU on the machine. I count that by physical sockets, and don't use the same ratio for DUO CPUs or dual core....
I'm sure some googling will reveal a more informed answer, but as a I say, I see things go poorly when load runs greater than 1.0 per CPU.
(i.e. 4 CPUs, load of 2.5, not too worried... probably stressing RAM or disk more than CPU).
Good luck.
D.E.R. Management - IT Project Management Consulting
It's the average number of running and scheduled processes over the last 1, 5, and 10-minute periods.
Definitely below 1, the closer to zero the better, over time. Occasional spikes are normal.
High load can be caused by cpu-intensive processes, but also by processes causing high iowait. Low memory, which causes paging, which causes iowait, can also increase the load number. When I've seen high load caused by disk congestion, usually the CPU% isn't very high.
Definitely below 1, the closer to zero the better, over time. Occasional spikes are normal.
High load can be caused by cpu-intensive processes, but also by processes causing high iowait. Low memory, which causes paging, which causes iowait, can also increase the load number. When I've seen high load caused by disk congestion, usually the CPU% isn't very high.
- Status
Similar threads
- Locked
- Question
- Locked
- Question