Upgrading Call Pilot 150 Software

[Serenitynow109]

Good Morning Everyone,

Has anyone done an upgrade from a pre 3.0 to 3.0 software on a Call Pilot 150? We have done many NAM's from either 3.0 or 4.0 to 4.1 and was wondering if similiar procedures
(discs, CD's, Keycodes)are necessary.

Thanks in advance

 

[senk1s]

download the software from nortel's website (partners only)
extract on to a CF card
Power down CP (verify bootloader compatibility - mentioned in the readme file of the sw download)
Place it on the 'top' slot
Power up - wait for bootup, monitor on com port
power down
take the 'top' card out and boot up

- remember reading a FAQ on this ...check that out

 

[Serenitynow109]

Interesting. I was just told from a Field guy that they removed the 2.0, unserted the 3.0 and in twenty minutes it was up and running.

senk1s, we are a partner so no issues there. Are you saying there is a patch needed to hold programming?

 

[senk1s]

that is a way to do it ... but all programming is lost (because it is stored onthe flash card)
if upgraded, everything is there