I have a running (in use) Cisco 2610XM router with 16 MB flash and 64 MB memory. I have recently aquired 16MB extra flash memory and additional 128MB memory for my router.
From what I've read on several sites I have to re-partition the flash to one "big" 32MB partition for use all of the flash memory.. How is that done?
"no partition flash 1" and then "partition flash 1 32" ??
do I run this from rommon or from configure mode ?
I know that I have to copy the ios image from tftp after I delete and repartition my flash..
I guess it is best to check how BEFORE I start so that the downtime is minimal..
From what I've read on several sites I have to re-partition the flash to one "big" 32MB partition for use all of the flash memory.. How is that done?
"no partition flash 1" and then "partition flash 1 32" ??
do I run this from rommon or from configure mode ?
I know that I have to copy the ios image from tftp after I delete and repartition my flash..
I guess it is best to check how BEFORE I start so that the downtime is minimal..
