unable to HyperTerminal to PBX anymore 1

[vwtang]

I was able to access PBX/VoiceMail remotely through HyperTerminal before.
Today through HyperTerminal I logged into PBX then VoiceMail. I was idle for a while. When I came back to the HyperTerminal, it did not respond to me at all. I had to disconnect and then exit the HyperTerminal. Then I dialed in again. After I typed the password for the PBX Modem, I got "Ok, You are now transparent to port 1". Then When I type "logi", the following message appeared in the HyperTerminal window:

22;1HK11;19r;1;4m17;53H22;1H;1mEnter a numeric value without imbedded blanks.K11
;19r;1;4m17;53H17;45H3601logi

I just could not log into the PBX through HyperTerminal anymore.

I can still log into PBX through local system terminal. However I can not access Voice Mail system anymore. When I do >AX, I get OVL0406 - Low speed link is used by the other terminal.

I know the whole situation was caused because I did not exit VoiceMail/PBX properly. Could some one please tell me how to solve this problem?
Many thanks!!!

 

[spanton]

If you have not resolve by now. Upon login and becoming transparent to the port. Press Ctrl R to refreash the screen in mail and you should be able to exit back to the PBX. If that does not help let me know.

 

[johnpoole]

perfect post, if that doesn't fix it, it may reset during midnights. if possible i would ini if i could and needed the switch

john poole
bellsouth business
columbia,sc

 

[vwtang]

Thanks, you all. My problem was gone.