New install. I have two 1751 routers with a WIC-1T serial card in each. Router "A" is 192.168.0.21 and I need router "B" to be at 192.168.0.22 . "A" side is where the domain / internet access reside. I keep getting a conflict when I attempt to set "B" on the same subnet. I have done this in the past with the same model of router - only I used a DSU card instead of serial. I know I need to configure "IBRP" (integrated bridging & routing protocol) and maybe setup BVI interface? What came very simple several months ago is now lost. I hope someone with a little more exposure to these routers can joggle their brains better than I. Thanks in advance. LDB
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Two 1751 routers on the same subnet
- Thread starter FlyboyLDB
- Start date
- Status
Similar threads
- Locked
- Question
