Trying to install a TN799 CLAN on release 7

[acwildcat]

I'm trying to install a TN799 C-LAN card. I have taken the other steps but don't have an option to "change ip-services" or "change ip-interface".

I can ping the switch successfully but can't get the site administrator to connect.

any suggestions?

-Ron

 

[gonzalez]

I cant remember what release exatly that started to support site administrator but I think it was 9.
There is a work around using the aux port on a cisco router.
If you do a search on this site you will find it.

 

[5essfun]

Are you trying to use the clan card for telnet access for switch admin? If so it is release 9 when "ip-services" become available. I use a program called IPComserver on a Windows PC to provide multiple serial ports for switch, Audix, etc. control via telnet. You can inexpensively add telnet access on earlier releases this way.

 

[mrjedi]

I believe it is only supported on V8

 

[telcoguy]

Only from 9.05 the SAT entry was added to the config.
On release 8 and early 9 releases, the board could only be used to do IP trunking(in combination with a Medpro board).


Rob

 

[AvayaDude]

One of the many PBXs I access is a G3Vr6. To gain lan connectivity through ASA, we installed a Lantronics UDS-10 worth approx $150.00 cdn.

 

[4merAvaya]

The only function supported by the C-LAN v=board in a G3V7 is adjunct connectivity (CMS/AUDIX).

Kevin