guerrerotech
Programmer
What would have to be done to get this to work??
Using a DTI module on bcm and DTI cartridge on MICS. Would this work????
Using a DTI module on bcm and DTI cartridge on MICS. Would this work????
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Trying to connect Bcm400 to MICS R6 is it possible???
- Thread starter guerrerotech
- Start date
- Status
Depends. What are you trying to accomplish? What release of BCM? There is a fiber expansion module available on the BCM side if your MICS doesn't use copper modules.
Are the two systems in the same room/building or are they geographically separated etc. Do you just want to connect the MICSs' station and trunk modules directly to the BCM or do you want to keep the two separated and just be able to call between them?
Can you elaborate for us?
Are the two systems in the same room/building or are they geographically separated etc. Do you just want to connect the MICSs' station and trunk modules directly to the BCM or do you want to keep the two separated and just be able to call between them?
Can you elaborate for us?
- Thread starter
- #3
guerrerotech
Programmer
They are going to be in the same phone room. They want to be able to do 4 digit dialing between the both of them.
stevethephoneman
Vendor
It should.
As long as there are no programming conflicts.
Use a crossover cable to connect the 2 systems.
As long as there are no programming conflicts.
Use a crossover cable to connect the 2 systems.
- Status
Similar threads
- Locked
- Question
- Locked
- Question