Trk to Trk Xfer on an Option 81 1

[telecomPA]

Hi, i need help redirecting traffic at one of our sites. We have 2 fax machines that need to get forwarded to another office. The numbers are DID's so i decided to test at another office first before implementing. i dialed in to an Option 11 where they have a local T-1, built a phantom TN, set up DCFW to an ACDN, then had the NCFW on the ACDN call my desk. When i tested it, it works fine.
The office where i tested this has VZN as the local provider and i sent the call out on AT&T. i turned on d-channel messaging on both d-channels and i can see the call come in and go out.
So i then tried it at another office where we have an Option 81 and the local circuit is VZN and the LD circuit is Zone Telecom.
I did the same thing and it fails every time. the call comes in to the PBX but never goes out. i checked the CDB and trk to trk xfer is enabled, the trunk members are set to NCOS 5, which is fine but it doesn't work. i never see the call xfer to the outbound trunks so i keep getting a busy.
any ideas as to what i should look for?

 

[johnpoole]

your using cfo so the inbound trunks ncos limits the call.. if your sending it back out the same route, use a maxp1 acd ncfw to the acod plus the number..

john poole
bellsouth business
columbia,sc

 

[GHTROUT]

Here is the CFF/CFO story:

http://www.ghtrout.com/rdr/cff-cfo.html

--
Nortel Resources at GHTROUT.com | Connect with me on LinkedIn
--

 

[telecomPA]

thanks gents but i'm not sending the call out the same route because it's an LD call from VA to PA. so call comes in on local PRI and i want to go back out on LD span.

i checked the RDR_Data field and i'm set to CFF, but the call doesn't transfer to the LD circuit. it's stuck on the local PRI. here's a print screen:

DCH 8 UIPE_IMSG CC_SETUP_IND REF 00000651 TOD 16:24:58 CK 59D08C02
CALLED #:69xx NUM PLAN: UNKNOWN TON: UNKNOWN
CALLING #:215xxxxxxx NUM PLAN: E164 TON: NATL

DCH 8 UIPE_IMSG CC_RELEASE_IND REF 00000651 CH 8 4 TOD 16:25:00 CK 59D0A5ED

 

[GHTROUT]

If the routes have NEDC and FEDC, set then all to ETH.

Also check the LD21 RDR_DATA for EXTT, etc.

--
Nortel Resources at GHTROUT.com | Connect with me on LinkedIn
--