Tie line hangs up too quickly?

[chevyman440]

Calling out over E&M wink tie line. Far end sends ringing tone back, but the Definity hangs up with the classic two tone warble approximately 10 seconds after the last digit is dialed. I changed a lot of the answer supervision values to no avail. If I answer the phone on the other side then it works fine.

This prevents me from ever making it to the voice mail system on the remote end.

Any idea where to look?
-Matt

 

[DAVIDPAYNE]

Is this suppose to be a DCS link?

 

[chevyman440]

Nope. Remote system is Asterisk (getting our feet wet before committing to a bigger voip system). Just 24 regular old voice channels.

I was wrong actually... it will hang up on me whether I answer the phone or not. It somehow doesn't realize a valid call is taking place?

-Matt

 

[tecman84341]

Chevyman, did you ever get this to work?
I am fighting the same problem
David

 

[chevyman440]

Tecman: Not yet. It has something to do with aar ars as far as I can tell. Now what I CAN do and it does work is forward my phone to, catch this, 98xxxx00 where xxxx is my asterisk extension. It will not hang up if I do it this way. I just chop off the two end digits on the asterisk side that get sent through.

So, somewhere the system doesn't like the shorter amount of digits.

That's all I know presently. The forward works okay as well as using my UDP table to route it to the right trunk.

-Matt