Term Server quit redirecting printers.

[g8orade]

Hi all,
All of a sudden my Term Server quit allowing users to populate their printers. Only thing major was a drive on the Raid 5 died just before the print redirection stopped. I have looked high and low and have not found a solution. I am thinking corrupt files but have no clue where to begin my search.Any ideas?
Thanks all.
G8orade

 

[markdmac]

Before you dig too deep try restarting the Print Spooler.

I hope you find this post helpful.

Regards,

Mark

Check out my scripting solutions at

http://www.thespidersparlor.com/vbscript

 

[g8orade]

Thanks Mark for quick response. I have rebooted the term server. The drive that was bad went into a defunct state is the reason I think file corruption. I had to shut server down to get the array to rebuild.
Thanks again,
G8orade