T1 Maintenance

[RonaldTB]

Where can I find documentations that shows the how steps to check a T1, and restart the T1 for the Avaya Communication Manager. I have used the following commands;
List trunk 1
Status trunk 1
Busy port 001v224
Rls port 001v224
Status sig 1

But if I rls the circuit what command do I use to establish the circuit back?

 

[montyzummer]

busy trunk x / relaese
busy sig x / release

whats your cm version and hardware ???.... the top two commands provided are the most simple way to reset a trunk , you need the reports doc for cm / events doc and turn on slip detection on the ds1..... and start with l meas ds1.(covered in the reports document)

APSS (SME)
ACSS (SME)
ACIS (UC)