MaXJohnson
MIS
Is there a command to display the real-time state of the signalling bits on a DS-1 channel?
TIA
TIA
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
T-1 signalling bits
- Thread starter MaXJohnson
- Start date
- Status
- Thread starter
- #2
MaXJohnson
MIS
Whoops!
The system I need to check signalling bits on a would be a G3R or G3si.
thanks
The system I need to check signalling bits on a would be a G3R or G3si.
thanks
Hi
Look, there is a manual for signaling bits definition
May be it helps you to identify the bit states to ds1 country protocol. And will no reason to see it in real time.
Look, there is a manual for signaling bits definition
May be it helps you to identify the bit states to ds1 country protocol. And will no reason to see it in real time.
- Status
Similar threads
- Locked
- Question