System keeps rebooting...looking for help

[richarddurham]

I have a centralized system with a 412 host. I have 13 other locations connected with a mixture of 401, 403 and 406 units. All units are on the same version 3.2.54. If I have to reboot my 412 at the main location, it will go into a constant reboot mode when it starts connecting the WAN port. Will cycle and reboot. When I take out the IP line to my Atlanta location out of the configuration and send and reboot, the system comes up fine. Also if I leave the Atlanta location in the configuration, but unplug my CSU and let the system come up, then power up my CSU, all works as it should.

My problem is I have looked at every configuration setting on my 412 and the 406 in Atlanta and cannot find what would be causing the reboot. Maybe something that is not in the config file. Looking for ideas.
Thanks guys

 

[aarenot]

I would start the monitor sofatware, set it to log to file. Do the reboots both ways, and see what the difference is between them in monitor report, and post it back.

I will have to think about what filter options to turn on, I have to run out now. Maybe someone else can run through what filters to turn on for monitor.