Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Switch Question

Status
Not open for further replies.
brady12345

brady12345

MIS
Joined
Sep 19, 2007
Messages
47
Location
US
How do you go about testing if one of the ports on a switch has failed? I was just curious of an easy way to do this from within the IOS without having to be physically at a location.
 
Sort by date Sort by votes
From enable mode, "show interface xxx" where xxx is the interface in question. The interface may show up / up, or up / down, etc.
 
Upvote 0 Downvote
Good point. Is there a command that will show me all of the MAC addresses so I can determine the devices port by matching up its mac address to the port?

Thanks in advance,

Brady
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Skip Rango
  • Locked
  • Question Question
how to backup cisco sg500-52p switch
Replies
1
Views
819
madwok
madwok
Zero6
  • Locked
  • Question Question
question about cisco cbs 350-12xs 12 port 10g sfp+
Replies
0
Views
517
Zero6
Zero6
khashyar2021
  • Locked
  • Question Question
Problem with cisco switch after upgrading
Replies
1
Views
463
Geraldine Souza
Geraldine Souza
bfordz
  • Locked
  • Question Question
new help on setting up third party VoIP phones through Catalyst 2960x switch
Replies
0
Views
368
bfordz
bfordz
NavinNet
  • Locked
  • Question Question
Why 2 different mac addresses of a server are being shown of CISCO 6509E Layer-3 Switch ?
Replies
0
Views
279
NavinNet
NavinNet

Part and Inventory Search

Sponsor

Back
Top