Hi Group,
My problem is noted by the asterisk (*) below:
(1) Insert a subreport in a group footer of the main rpt. The main report & subreport are each based on different stored procedures, but both involve the same two stored proc parameters. The subrpt also contains the same two groups as in the main rpt.
(2) Link the subreport and main report by the two stored proc parameters plus the reports' two group-by values.
* PROBLEM: the stored proc parameters pop up repetitively when I run the main report. I double-checked that my parameters were linked correctly by leaving the "Select" bottom drop-down box empty, per discussion in the Crystal forums here.
Any ideas on this would be much appreciated! Thanks for your time.