STOP Error in Recovery console

[dustbuster]

Whenever I try to boot into the Recovery Console I get the STOP Error in Windows XP Home (sorry couldn't find the Windwos XP Home forum):

A problem has been detected and windows has been shut dow to prevent damage to your computer.
<Standard Reboot Stuff>
Technical Information
*** STOP: 0x0000007B (0xF898D524, 0xC0000034, 0x00000000, 0x00000000)

I get the error on two systems (the ones using P5LD2-VM DH motherboard) regardless if I take out our PCI cards or not.

I don't even have a chance to use the recovery console. The system loads whatever it loads and before I get to choose "Install Windows" or "Troubleshoot a Windows installation" I get the error.

I don't get this STOP error when I boot Windows normally or in Safe Mode.

Any help would be great.

 

[bcastner]

It means that the mass storage controller you are using requires drivers that are not in the base installation of XP. Discussion and possible workarounds:

. For CD Access:

http://support.microsoft.com/kb/314082/

. Install the Recovery Console -- as the drivers will be there on the hard drive.

You can do this inside of XP:

http://support.microsoft.com/defaul...port/kb/articles/q307/6/54.asp&NoWebContent=1

____________________________
Users Helping Users

 

[linney]

Are you required to load drivers by pressing F6 as the Recovery Console is loading, ( F6 - To install third-party SCSI and host controller drivers)?

 

[dustbuster]

Ok. I installed the Recovery Console and I can access it now.

I think I need to find a way to actually fix this issue because when I use BartPE (based off of Windows XP Home) I get the same error.

I don't think I have any third party drivers