Spa 112 disconnect timer

[daveinwearside]

Hi Im using a Spa 112

can make and take calls fine but when the far end hangs up the device on the ATA doesnt clear down.

ive adjusted the CPC timer but cant see to get it to work.

any ideas?

cheers
Dave

ACSS SME
APSS SME

A word to the wise ain't necessary - it's the stupid ones that need the advice.

 

[holdmusic34]

This thread is the closest i could find. I've never seen the product.

I feel you may be best served by asking in the Cisco Tek Tips forum, or dare i say it, the official Cisco forum i linked to.

https://supportforums.cisco.com/t5/...one-instead-of-reorder-busy-tone/td-p/2453740

daddy? are you doing blah blah blah things again?

 

[sizbut]

https://www.cisco.com/c/en/us/td/do...0-200/admin_guide_SPA100/spa100_ag/voice.html

CPC Delay
Delay in seconds after caller hangs up when the ATA starts removing the tip-and-ring voltage to the attached equipment of the called party. The range is 0-255 seconds. This feature is generally used for answer supervision on the caller side to signal to the attached equipment when the call has been connected (remote end has answered) or disconnected (remote end has hung up) This feature should be disabled for the called party (in other words, by using the same polarity for connected and idle state) and the CPC feature should be used instead.
Without CPC enabled, reorder tone will is played after a configurable delay. If CPC is enabled, dial tone will be played when tip-to-ring voltage is restored. Resolution is 1 second.
Default setting: 2

CPC Duration
Duration in seconds for which the tip-to-ring voltage is removed after the caller hangs up. After that, tip-to-ring voltage is restored and the dial tone applies if the attached equipment is still off-hook. CPC is disabled if this value is set to 0. Range: 0 to 1.000 second. Resolution is 0.001 second.
Default setting: 0.5



Stuck in a never ending cycle of file copying.