Solid amber LED on RPS 2300

[grpsmis]

Have Cisco stack of 3750G -48 port(3) with stackwise cables; working ok. Have new Cisco RPS 2300. Cables connected to back of each 3750G in stack. On front of RPS panel, two LED's blinking green (ready to supply power if needed)but the other LED is solid amber which I read indicates that the RPS power is not available. Does anyone know why this would be the case? Nothing different was done to the 3rd switch in stack. Same cable used running to RPS. All three 3750G's where up when we attached to back of RPS with the three cables for the RPS. Cannot configure RPS via cammand line since these are NOT 3750E calss switches. Any ideas would help. Thanks.

 

[vipergg]

That may be normal , those can only "actively" backup 2 devices at a time which might be why 2 show normal and the 3rd is amber. Here is some info on that device.

http://www.cisco.com/en/US/prod/col...8/ps7148/ps7130/prod_qas0900aecd805bbf21.html

 

[grpsmis]

Thank you Viper, After looking at the MANUAL a bit more. discovered that it is indeed normal operation. This is a new device for us. Thanks for the timely reply.