SNMP Trap Setup - How to?

[demanding]

Running MM 5.2 on 2 S8730s/Windows. How do I turn on SNMP traps to an internal device...where is this done?

 

[texeric]

In the VMSC for the VMD. Serviceability I believe is the area you are looking for.

http://www.theviagroup.com

 

[demanding]

Thanks - too simple! However, when I click on ADD, I get this:

IP Address/Host Community Type Port Status
Enter address Public INADS 162 Inactive

I don't seem to have an option to edit this...ideas?

I read in some documentation "for SIP implementations with System Platform, the Alarm Origination should be SAL. There are no SNMP Trap Destinations with SAL" which we have all that - so does that mean we cannot have SNMP traps while SAL is being used?

 

[KenMeans]

you have to add a community first and then add the snmp trap info

Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[demanding]

Yes - figured that out after posting. But do you see any reason it should not run in conjunction w/SAL?

 

[KenMeans]

i have never tried that but i would think it would work.


Ken Means

http://www.tel-is.com

"I find that the harder I work, the more luck I seem to have."
- Thomas Jefferson (1743-1826)

 

[demanding]

Ok - thanks much!

 

[demanding]

That all worked just fine - thank you both!