Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SMDR reading by application
- Thread starter pnagy
- Start date
Hook up to the com port of the unit. Use a utility tool like Hyperterm or anyother type application.
The default settings are Baud rate 9600, Data bits 8, parity none, stop bits 1, flow control none.
wait about 10 seconds and away you go. If you don't have the SMDR turned on e-mail me and I e-mail you the instructions on how to complete that leg of the project, but I believe you'll be ok out of the box.
ddoran@isttinc.com
The default settings are Baud rate 9600, Data bits 8, parity none, stop bits 1, flow control none.
wait about 10 seconds and away you go. If you don't have the SMDR turned on e-mail me and I e-mail you the instructions on how to complete that leg of the project, but I believe you'll be ok out of the box.
ddoran@isttinc.com
- Status
Similar threads
- Locked
- Question
- Locked
- Question