Simple Router question (enable the 'enable' function)

[b8con]

How do i enable the 'enable' function for when people telnet into the router?

I mean, how do i make it so that, when people telnet into the router, they would arrive at the "Router>" mode, instead of the "Router#" mode

i already have a enable password and enable secret password setup, but telnet users don't have to put it in.

anyone know why?
thanks.

 

[JOAMON]

AAA authentication with usernames setup with privelage level 15 and after they sign in they will be at router#.

 

[jneiberger]

b8con, are you saying that people go directly to enable mode upon logging in? If so, remove the "privilege level" commands from your VTY lines.

HTH,
John

 

[reliancetech]

Undderstand few simple things in your running config will give you idea

1) username Cisco password 7 096F471A1A0A -- This command means you have to give username and password to reach > prompt. Basically command is
config#username Cisco password Cisco
but run config will by default save it as encrypted password.

2) enable secret 5 $1$nWbH$Xb.DuW5ZkzUhyre/1r -- This command sets the password for entering to configuration mode
that is # prompt.

3) line vty 5 15 -- This will enable your telnet session. And when you have Username command set the telnet will by default ask you Username and password and then will come to > prompt.