desperado618
MIS
I would like to display the contents of group objects however whenever I run "get address | i <Addressname>" i only get the name of the object. Can someone assist me on my quest?
Thanks
Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Simple "Get address" command question
- Thread starter desperado618
- Start date
- Status
Hello,
You should be able to obtain the details of the group using the "get address <zone> group <name>" command. In the example below, I've used the command to show me the contents of the "LAN" group in the Trust zone.
"get address trust group LAN"
Hope this helps.
Rgds,
John
You should be able to obtain the details of the group using the "get address <zone> group <name>" command. In the example below, I've used the command to show me the contents of the "LAN" group in the Trust zone.
"get address trust group LAN"
Hope this helps.
Rgds,
John
- Status
Similar threads
- Locked
- Question
- Locked
- Helpful tip