Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

sh int command 1

Status
Not open for further replies.
mcgruff04

mcgruff04

MIS
Joined
Apr 29, 2008
Messages
5
Location
US
When using the sh int command, one bit of information we get is the txload/rxload.

Does anyone know what interval the interface is polled to get this ratio?
 
Sort by date Sort by votes
Its 5 minutes by default..

You can modify it by doing the 'load-interval' command under the interface..


BuckWeet
 
Upvote 0 Downvote
You'll also want to do a "clear counters" in global config every now and then...

Burt
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

BleuBell
  • Locked
  • Question Question
Command Rejected : Exceeded NNI ports Allowed
Replies
0
Views
325
BleuBell
BleuBell
dogg1
  • Locked
  • Question Question
CUCM SNMP Set Command
Replies
1
Views
662
whykap
whykap
PThomp3344
  • Locked
  • Question Question
Trying to connect to Cisco Unified Controller web interface: UC520W-16U-4FXO-K9
Replies
1
Views
683
nt8d09
nt8d09
NavinNet
  • Locked
  • Question Question
Why 2 different mac addresses of a server are being shown of CISCO 6509E Layer-3 Switch ?
Replies
0
Views
277
NavinNet
NavinNet
MoJHK
  • Locked
  • Question Question
Metro Ethernet trouble shootin
Replies
0
Views
312
MoJHK
MoJHK

Part and Inventory Search

Sponsor

Back
Top