Setup CDR

[jensjuul]

Hi,

I am trying to setup CDR on my Meridian PBX but I have not had luck yet. What steps do I need to do?

LD 17 - Setup a port to collect, right?

and then enable it on the trunks?

Do you have a step-by-step for setting up CDR?

Thank you very much!

 

[StoneColdphoneman]

The only thing you are missing is to add the tty port in to the CDR_Data.

 

[jensjuul]

I get an error when I try to setup the port.

In LD 17, what do I need to set the port to? I have SDI interface for the CDR port.

 

[Nortellian]

user cty

 

[jensjuul]

Done that... It still comes with an error - an SCH error

 

[jamie2]

ADAN TTY 8
CTYP SDI2
GRP 0
DNUM 8
DES CDR_1200_B
FLOW NO
USER CTY
XSM NO


PAST YOUR SCH code when trying to build

 

[jensjuul]

Hi, I've setup this up in LD 17

ADAN TTY 1
TTY_TYPE SDI
CAB 00
CARD 00
PORT 1
DES CDR
BPS 19200
BITL 7
STOP 1
PARY NONE
FLOW NO
USER CTY

When I try to add CDR in LD 15 I get the following:

TYPE CDR_DATA
CUST 0
CDR yes
AXID yes
TRCR yes
CDPR yes
ECDR yes
BDI yes
OTCR yes
PORT 1
PORT 1
SCH0915
PORT

So my error is SCH0915. Do you know what this means?

Thank you so very much.

 

[acewarlock]

Print and post TYPE CDR_DATA

 

[jensjuul]

Didn't I just post the CDR_DATA?

 

[acewarlock]

No you posted what you were trying to do, not what is there already.

 

[jensjuul]

Ahh, sorry

I cannot do anything with the LD 15 in CDR_DATA since it does not accept the port I am trying to set.

When I print LD 15 CDR_DATA I just get CDR NO.

 

[jensjuul]

Do you know if there is a walkthrough in the documentation? I have looked for it, but I have not been able to find a step-by-step guide.