Setting up remote location w/VPN

[rrgrassi]

Hello all,

I am a newbie to Cisco and I have been tasked with setting up a remote site out of state. We are based in Greenville, Tx, and now have a site in Tracy, CA. HQ has two 515e's as failover. Tracy is getting a 506e. Currently, we have VPN in to our network for those that travel. I need to allow VPN into our new location, and have no idea how to config this. The 506 has it's factory default settings in place. I would like to know if there are any sample configs out there. I was wondering if I could use the 515 config on the 506, but without the failover and by changing the VPN settings. Both are running 6 (3).

Thanks!



rrgrassi

 

[themut]

The link below is an excellent guideline for your task:

http://www.cisco.com/en/US/products...s_configuration_example09186a0080094761.shtml

 

[rrgrassi]

Ok, thanks! I'll give that a shot. I have to "preconfig" prior to going out to our new remote site.

rrgrassi