Setting up Norstar as a PBX Template

[GMgerry]

Customer needs to change to a PBX from a square system asap. Anyone have any quick temple I could refer to for prgraming from scratch.

CICS 8x24
CP100

Thanks

 

[lugerlover]

why ..what do you need to exactly do???

these broad wide open questions are tedious

 

[GMgerry]

I have not done a PBX install of a Norstar and the customer wants to change over the holiday and just looking to save some time and problems. I know that the programming will be lost buy resetting the template but if I can get the basic information straight I can do the rest of the programming by OLP. When I start a new OLP for a PBX it will not let me set up a prime line/Intercom on the first button. etc. so I know somethings not right. And I sure don't want that on a Holiday weekend.

Any help would be great, thanks.

 

[lugerlover]

should only take about 30 min to reprogramm 24 sets...just program 1 and copy...doa restart and start from there...again its not brain surgery...and excuse sarcasm was laid off after 20 yrs this week and it must come out some where

 

[GMgerry]

Thanks and understood. I may be back for additional questions. I'm trying to rebuild it this weekend so they can see it be fore I do it.

Soory on your job lose. Is there an area were the list can help you reconnect with employment?