I have set my management interface IP to an open static IP address on my internal network so that I can configure the device. I want to set the IP of e0/1 to an other IP on that same subnet = to the IP of my existing firewall and have the interface shut until I am ready to cut over. When I set the IP it gives me an error because the device is on the same vlan am I able to do what I'm trying to do?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Setting Interface IP Addresses
- Thread starter jfp23
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question