selecting multiple fastethernet ports to configure

[Guest_imported]

How do you in the command line interface select multiple fastethernet ports to configure?

Basically what I need to do is configure over 60 new 3500 series switches we just got in and all of them need the fastethernet ports with spantree portfast enabled

I know how to do this, but I have to do it one port at a time. I heard there is a way to select multiple fastethernet interfaces to simplify and shorten the process.

Thanks

 

[BuckWeet]

Can't do it unless you have CatOS or some of the newer high end IOS based switches...


Sigh! I know your pain..


BuckWeet

 

[Guest_imported]

thanks for the info... I've seen it done on a 6500 that we have, I was hoping it wasn't only the high end stuff that it was possible on.

I found that pasting a preconfigured text file is the easiest way... It works good.