Security Domain commands?

[NortelGuy1979]

All,

My NTP's, my training books from class, and my memory from 6.0 class all say that these commands should be in PDT:

joinSecDomain
leaveSecDomain
statSecDomain

However, I'm in a PBX that is not currently registered to the sec domain (installers used ! in passwords, aargh), and wanted to re-register it in PDT to get around the ! in the password (per the bulletin).

The commands don't seem to exist, and I'm in with local PDT2 privileges:

pdt> lkup "SecDomain"
statSecDomainSysListRefresh 0x31625562 text
statSecDomainSys 0x316264c1 text
securityDomainStatSecDomainSys 0x31626533 text
pdt> lkup "join"
pthread_join 0x31bd9130 text
igmp_joingroup 0x31b5dab0 text
joint_iso_ccitt 0x31fd4e74 data
pdt> lkup "leave"
leaves.0 0x320da458 bss (local)
__gthread_leave_tls_dtor_context 0x31c339b0 text
igmp_leavegroup 0x31b5d9d0 text
__gthread_leave_tsd_dtor_context 0x31c339d0 text
pdt>


Anyone seen this? This is a 6.0 CPPL; is it because it's co-res?

-Matthew

Matthew - Technical Support Engineer

http://www.linkedin.com/in/matty79

 

[Triton101]

i think LD 117 in the Call server

__________________________________________________________
Find a job you love and you'll never work a day in your life. - Confucius

 

[NortelGuy1979]

Can't via LD 117 in call server - ! in password. Until I get network access to site to change UCM passwords, I can't use PBX CLI except PDT.

BULLETIN ID: 2009009846, Rev 1
PUBLISHED: 2009-11-09
STATUS: Active
REGION: APAC
CALA
EMEA
GC
NA
PRIORITY: Information
TYPE: Alert

-Matthew

Matthew - Technical Support Engineer

http://www.linkedin.com/in/matty79

 

[Triton101]

oops did not see your "!" issue in your post...

not sure if there is a way to disable central authentication without putting in the flash card at site......

__________________________________________________________
Find a job you love and you'll never work a day in your life. - Confucius

 

[NortelGuy1979]

Not if you don't have UCM login rights, no, but luckily, my installers were boneheaded and admin1/admin2 existed both on the UCM and on the PBX.

SOO - I had logged in via admin2 in central auth mode, removed central auth, then did all I needed in regular mode...

Sent someone to site, fixed the passwords all the way around, and re-joined everything.

Still wonder why those PDT commands weren't there, symbols were loaded and everything.

-Matthew

Matthew - Technical Support Engineer

http://www.linkedin.com/in/matty79